#31 Issue closed: BUG BUG BUG! Could not determine size of disk

Labels: bug, waiting for info

dagwieers opened issue at 2012-03-28 20:08:

Reported by Dan H. Musil at SF#3441168 on 2011-11-22 09:01:53 PST

Original report

This issue appears in both 1.11 and 1.12 but does not appear in 1.10.

Setup
Intel machine with RAID5 root disk, (sda) and four paths to a single SAN LUN, (sdb, sdc, sdd, and sde), presented using multipath, (mpatha). The device /dev/mapper/mpatha was partitioned to a single partition, /dev/mapper/mpathap1, and presented to LVM. A single volume group was create and a single logical volume created. The logical volume was then formatted as EXT4 and mounter to the system.

ReaR 1.12 was installed and the /etc/rear/local.conf, (attached), file was put int place from the original 1.10 installation. (IPs have been changed to protect the innocent. :-) )

Every time the command 'rear mkbackup' is run, the following is displayed...

[root@server ~]# rear mkbackup
ERROR: BUG BUG BUG! Could not determine size of disk sdb/sdb1, please file a bug.
Please report this as a bug to the authors of Relax and Recover
ERROR: BUG BUG BUG! Could not determine start of partition sdb1, please file a bug.
Please report this as a bug to the authors of Relax and Recover
ERROR: BUG BUG BUG! Could not determine size of disk sdc/sdc1, please file a bug.
Please report this as a bug to the authors of Relax and Recover
ERROR: BUG BUG BUG! Could not determine start of partition sdc1, please file a bug.
Please report this as a bug to the authors of Relax and Recover
ERROR: BUG BUG BUG! Could not determine size of disk sdd/sdd1, please file a bug.
Please report this as a bug to the authors of Relax and Recover
ERROR: BUG BUG BUG! Could not determine start of partition sdd1, please file a bug.
Please report this as a bug to the authors of Relax and Recover
ERROR: BUG BUG BUG! Could not determine size of disk sde/sde1, please file a bug.
Please report this as a bug to the authors of Relax and Recover
ERROR: BUG BUG BUG! Could not determine start of partition sde1, please file a bug.
Please report this as a bug to the authors of Relax and Recover
Aborting due to an error, check /tmp/rear-sysixrl004.log for details
Terminated
[root@server ~]#

I have attached the log file for this run as well.

dagwieers commented at 2012-03-28 20:09:

More information is in the old bug report at SF#3441168

jhoekx commented at 2012-03-29 11:09:

This should have been fixed on trunk since 0aa4831668105d67977fe756fcd6acf9725960bc. Please test a recent snapshot release.

[Export of Github issue for rear/rear.]